Cummins — ASSEMBLY

Lubricating Oil System Lubricating Oil Pump Body and Cover Bushing - Replacement (07-07) N14 Page 7-23 Install the boring bar through the guide bushing. NOTE: The tool bit must go through the slot in the guide bushing. Do not allow the tool bit to hit against the guide bushing. With the feed control level in the position, move the drive shaft down until the tool bit touches the bushing in the cover. Hold a new bushing and a 1.57 mm [0.062-inch] feeler gauge against the drive shaft at the top of the boring tool body. Move the stop collar down against the feeler gauge and tighten the set screw. Move the feed lever to the position. Remove the feeler gauge and the bushing.