Cummins — ASSEMBLY

Lubricating Oil Pump Body and Cover Bushing - Replacement (07-07) Lubricating Oil System N14 Page 7-22 Use a cutting oil, and cut the bore in both bushings in the oil pump body. NOTE: Do not push down on the drill motor. The feed mechanism in the boring tool will move the boring bar. Stop the drill motor, and move the feed control lever to the position. Pull up on the drive shaft to remove the tool bit from the bore. Remove the boring tool from the oil pump body. NOTE: The tool bit must move through the slot in the guide bushing. Do not allow the tool bit to hit against the guide bushing. Clean the metal particles from the oil pump body. Install the cover on the oil pump body.

Install the boring tool to the pump body. NOTE: Use the long capscrews and the nuts to fasten the tool to the oil pump body.