Lubricating Oil System Lubricating Oil Pump Body and Cover Bushing - Replacement (07-07) N14 Page 7-21 Turn the adjusting knob clockwise to push the tool bit against the indicator tip. NOTE: Adjust the tool bit until the indicator is set to the same size as the setting standard. Tighten the set screw and remove the adjusting knob. Install the boring tool into the guide bushing. NOTE: The tool bit must go through the slot in the guide bushing. Do not allow the tool bit to hit against the guide bushing. Adjust the travel of the boring bar so the tool bit will go through the guide bushing but does not touch the bush- ing in the oil pump body.
Use capscrews to fasten the boring tool to the oil pump body. Rotate the boring tool shaft to make sure it will turn freely. NOTE: The pump and the boring tool must be in a vertical position. Make sure the boring tool can cut completely through the bushings. Move the feed control lever to the position. NOTE: This will prevent the drive shaft from moving down. Install the drive adapter into a heavy duty 3/8-inch drill motor, and engage the adapter with the drive shaft of the boring tool.