Cummins — ASSEMBLY

Lubricating Oil Pump Body and Cover Bushing - Replacement (07-07) Lubricating Oil System N14 Page 7-20 Assembly Use bushing mandrel, Part No. ST-1158, to push the new bushings into the oil pump body and cover. NOTE: The bushings must be installed level with or no more than 0.51 mm [0.020-inch] below the surface of the oil pump body or cover. Use lubricating oil pump boring tool, Part No. 3375206, to cut the bore in the new bushings in the oil pump body and the cover. Install the guide bushing into the gear pocket. Tighten the capscrew against the side of the gear pocket to hold the guide bushing in position. Install the dial indicator into the setting block.

Install the setting block on the setting standard. Adjust the dial indicator. NOTE: The indicator tip must be set on the diameter size of the new bushing bore to be cut. Bushing I.D. (New) mm in 22.28 MIN 0.877 22.30 MAX 0.878 Install the tool bit into the boring bar. NOTE: Do not completely tighten the set screw. Install the tool bit adjusting knob into the boring bar. NOTE: Hold the setting block and the indicator against the boring bar so the indicator tip will be over the tool kit.