Cummins — TESTING - OIL COOLER CORE

Lubricating Oil System Lubricating Oil Cooler Assembly - Rebuild (07-11) N14 Page 7-33 Inspect the o-ring on the retaining plug for cuts or tears. Replace the o-ring if damaged. Inspect the teflon o-ring on the poppet valve for wear, cuts, or tears. Replace the complete poppet valve if there is any damage. Testing - Oil Cooler Core Caution: Do not reuse an oil cooler core after an engine failure since there is not a practical method to clean the cooler core. Metal particles which can circulate through the lubricating system can remain in the cooler core and can cause engine damage.

Do not allow dirt or gasket material to enter the oil passages when cleaning the oil cooler and the cylinder block surface. Install and clamp a short section of hose over either the inlet or outlet transfer tube of the oil cooler. Install a plug into the opposite end of the section of hose and install the clamp.