Flywheel - Removal Engine Disassembly (00-01) N14 Page 0-18 Adjust the position of the engine so that the remaining mounting holes in the adapter plate (1) and (2) align with the capscrew holes in the cylinder block. Use your fingers to tighten the three 1/2-13 X 3 3/8-inch capscrews (1). Install four 3/8-16 X 3 3/8-inch capscrews in the location shown (2). Use your fingers to tighten the capscrews. Tighten all the adapter plate mounting capscrews in the sequence shown. Torque Values : 3/8-inch 41 [30 ft-lb] 1/2-inch 102 [75 ft-lb] 5/8-inch 102 [75 ft-lb] Flywheel - Removal Install two 1/2 - 13 X 1 1/2 puller capscrews which have a minimum of 1 1/4-inch threaded area at points (1) and (2).
Remove capscrews (3) and (4), and install two 5/8 - 18 X 6-inch guide studs.