Engine Disassembly (00-01) Flywheel Housing - Removal N14 Page 0-19 Determine the capscrew thread size, and install two ‘‘T- handles’’ in the flywheel at points (4) and (5). Remove the remaining four flywheel mounting capscrews. Warning: Because this part weighs more than 23 kg [50 lbs], two people or a hoist will be required to lift the flywheel to avoid personal injury. Tighten capscrews (1) and (2) in alternating sequence to loosen the flywheel. Flywheel Housing - Removal Remove capscrews (1) and (2), and install two 5/8 - 18 X 4-inch guide studs. Warning:
Because this part weighs more than 23 kg [50 lbs], two people or a hoist will be required to lift the flywheel housing to avoid personal injury. Remove the remaining capscrews and the flywheel hous- ing. NOTE: Use a mallet to loosen the housing from the dowels in the cylinder block if necessary. Remove the guide studs.