Cooling System Water Pump Assembly - Rebuild (08-02) N14 Page 8-7 Water Pump Assembly - Rebuild (08-02) Disassembly Remove the pulley with puller, Part No. 3375257. Remove the impeller with puller, Part No. 3823040. Remove the retaining ring that holds the bearing assem- bly and shaft in the body. Support the pulley side of the body in an arbor press. Push the shaft from the impeller end to remove the out- side oil seal, bearings, and the shaft from the body. Use a punch and a hammer to remove the inner oil seal and the slinger from the shaft. Discard the inner oil seal and slinger. Support the impeller side of the body.
Use a punch and a hammer to remove the water seal and seat assembly from the body. Discard the seal and seat assembly. Use bearing disassembly fixture, Part No. ST-1114, to support the outer bearing and bearing spacer. Push the shaft from the bearing and the spacer. Discard the bearing.