Cummins — ASSEMBLY

Water Pump Assembly - Rebuild (08-02) Cooling System N14 Page 8-12 Use water pump bearing mandrel, Part No. ST-658, to support a new outer bearing. Install the shaft and the spacer into the bearing. NOTE: Push the shaft through the bearing until the bearing is against the spacer. Make sure the inner race of the bear- ing is not overloaded from contact with the spacer. The bearings must rotate freely. Install a new inner oil seal and a new slinger onto the shaft. Use seal expander, Part No. 3823885, to install the seal. Use water pump slinger driver, Part No. 3823816, to press the slinger to the proper location.

Prepare the outside diameter surface of the bearing with Locktite W Primer T, Part No. ST-1272-13. Apply a thin film of Locktite W 609, Part No. 3823718, to the outside diameter of the bearings. Support the impeller side of the water pump body in an arbor press. Use water pump mandrel, Part No. ST-658, to install the bearing and shaft assembly in the water pump body. Install the retaining ring into the groove in the water pump body. NOTE: The flat side of the bearing retaining ring must be installed toward the bearing.