Cooling System Water Pump Assembly - Rebuild (08-02) N14 Page 8-11 Shaft Journal O.D. Point mm in 1 19.121 MIN 0.7528 19.128 MAX 0.7531 2 25.011 MIN 0.9847 25.022 MAX 0.9851 3 15.905 MIN 0.6262 15.918 MAX 0.6267 Visually inspect the bearing retaining ring for nicks or cracks. Discard damaged parts. Assembly Use clean 15W-40 oil to lubricate the water pump shaft. Use water pump bearing mandrel, Part No. ST-658, to support a new inner bearing. Install the shaft into the bearing. NOTE: Push the pulley end of the shaft through the bearing until the bearing is against the large diameter (shoulder) of the shaft. Visually inspect the bearing spacer for cracks or damage.
Check the thickness of the bearing spacer. Bearing Spacer Thickness mm in 7.97 MIN 0.314 8.18 MAX 0.322 Install the bearing spacer on the shaft. Fill both bearings and the cavity of the spacer between the water pump bearings with Chevron SRI grease or its equivalent.