Water Pump Idler Assembly - Rebuild (08-04) Cooling System N14 Page 8-16 Remove the capscrew and the washer. Press the shaft out of the bearing. Discard the bearing. Cleaning Use solvent to clean the idler assembly parts. Dry with compressed air. Inspection Visually inspect the idler pulley for cracks or damage. Visually inspect the pulley grooves for wear or damage. NOTE: If the part being inspected does not meet the spec- ifications given or if damaged or no alternative is given, the part must be replaced. Measure the inside diameter of the idler pulley bearing bore. Idler Pulley Bearing Bore I.D. mm in 61.996 MIN 2.4408 62.012 MAX 2.4414