Cooling System Thermostat Housing - Cleaning and Inspection (08-05) N14 Page 8-19 Install the oil seal with the lip toward the bearing. Use seal expander, Part No. 3823885, to guide the seal onto the shaft. Use a tube mandrel to press the seal in flush with the pulley. Press the cover and a new o-ring into the pulley. Thermostat Housing - Cleaning and Inspection (08-05) Disassembly Remove the four thermostat cover capscrews and dis- assemble the thermostat housing. If the thermostat housing assembly is being replaced, remove the CELECT™coolant temperature sensor at this time from the thermostat housing. Remove the thermostat from the cover.