Cummins — ASSEMBLY

Water Pump Idler Assembly - Rebuild (08-04) Cooling System N14 Page 8-18 Support the idler pulley in an arbor press. Use bearing installation tool, Part No. ST-658, to press the bearing into the pulley until the bearing is against the bottom of the bearing bore. Install the retaining ring into the groove in the idler pulley. NOTE: The flat side of the bearing retaining ring must be installed toward the bearing. Push the shaft into the bearing by hand. Install the flat washer and the capscrew. Make sure the flat side of the washer is against the bear- ing. Torque Value: 27 [20 ft-lb]