Drive Units Accessory Drive Pulley Wear Sleeve - Replacement (09-05) N14 Page 9-15 Use a fine grit emergy cloth dipped in clean lubricating oil to remove minor defects. Use a crocus cloth for final polishing operation and to remove any remaining deposits on the pulley wear sleeve mounting boss. Clean the wear sleeve mounting boss with a clean cloth. Measure the pulley wear sleeve mounting boss outside diameter. Wear Sleeve Fit Area O.D. mm in 50.77 MIN 1.999 50.82 MAX 2.001 Installation Support the accessory drive pulley in an arbor press. Install the wear sleeve on the pulley seal wear surface with the chamfer on the outside diameter of the wear sleeve facing up (away from the pulley).
Place a flat steel plate on top of the wear sleeve. Press the sleeve on the pulley until the steel plate contacts the pulley. Inspect the wear sleeve for damage or burrs.