Cummins — CLEANING AND INSPECTION

Accessory Drive Pulley Wear Sleeve - Replacement (09-05) Drive Units N14 Page 9-14 Grind a 1.57 mm [0.062-inch] radius on the cutting edge of a 19.05 mm [0.75-inch] chisel. Place the chisel point against the wear sleeve. Use mod- erate blows with a hammer to strike the chisel at four points on the outside diameter of the wear sleeve to relieve the press fit. After the press fit has been relieved, remove the wear sleeve by hand. Cleaning and Inspection Use a crocus cloth to remove any deposits from the pulley wear sleeve mounting boss. Inspect the pulley wear sleeve mounting boss for minor nicks, scratches, sharp edges, or other damage.