Cummins — ASSEMBLY

Exhaust Manifold - Cleaning and Inspection for Reuse (11-01) Exhaust System N14 Page 11-4 Exhaust Manifold - Cleaning and Inspection for Reuse (11-01) Disassembly Use a mallet to remove the exhaust manifold sections. Cleaning Use a wire brush to remove carbon from the gasket seal- ing surfaces. Use penetrating oil and wipe the wear coated slip joints clean of carbon. NOTE: Do not use abrasive materials to clean the wear coated slip joints on the manifold sections. Abrasives will damage the wear coating. Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam will cause serious personal injury. Use steam to clean the manifold sections.

Dry with com- pressed air. Inspection Visually inspect the manifold sections for cracks or dam- age. Visually inspect the sealing connection surfaces for dam- age. Visually inspect the center section for damaged turbo- charger mounting stud threads. Replace damaged parts. Refer to Exhaust Manifold Turbo- charger Mounting Stud - Replacement (11-02). Check spacers and mounting flange for fretting, etc. Assembly NOTE: The exhaust manifold sections must be assembled on a flat surface for proper alignment. Install the exhaust manifold end sections to the center section.