Engine Dynamometer - Install Engine (14-01) Engine Testing N14 Page 14-10 Visually inspect the engine for coolant leaks. Repair all leaks found. The intake air piping must be plumbed through an af- tercooler to control the temperature of the intake air dur- ing the run-in procedure. Rig an aftercooler beside the engine, and plumb the intake pipes from the turbocharger, through the aftercooler and back to the intake manifold. Use a temperature gauge to measure the intake manifold temperature. NOTE:
Maintain the intake manifold air temperature at 66°C [150°F] or below during the dynamometer testing or run-in; if manifold temperature exceeds this limit, terminate the test and idle the engine to let it cool down. Do not idle more than 10 minutes. Testing can resume when the intake air tem- perature can be maintained below 66°C [150°F]. Under no circumstances is the intake manifold air temperature al- lowed to exceed 77°C [170°F]. Install a water manometer to the air inlet pipe of the turbocharger to measure inlet restriction. NOTE: The manometer adapter must be installed at a 90 degree angle to the air flow in a straight section of pipe, one pipe diameter before the turbocharger. NOTE:
A vacuum gauge can be used to record the intake air restriction. Minimum Gauge Capacity: 760 mm H 2 0 [30 inches H 2 0]. Install a mercury manometer to a straight section of the exhaust piping near the turbocharger outlet to measure exhaust restriction. NOTE: The manometer must be scaled to record exhaust back pressure in excess of 75 mm [3.0 inches] of mercury. NOTE: A pressure gauge can be used to record the exhaust back pressure. Minimum Gauge Capacity: 254 mm Hg [10 inches Hg].