Engine Testing Engine Dynamometer - Install Engine (14-01) N14 Page 14-11 Remove the straight thread fitting in the accessory drive and install the lubricating oil temperature sensor. Remove the pipe plug from the main oil rifle drilling in the cylinder block. Install the lubricating oil pressure sensor. Remove the pipe plug in the intake manifold just below the inlet air connection and install the intake manifold pressure gauge. Install the Part No. 3375150, Engine Blowby Tool, to the breather on the rocker lever cover to measure engine crankcase pressure. Install a water manometer, Part No. ST-1111-3, to the engine blowby tool. Install a plug in the crankcase breather vent tube. NOTE:
A pressure gauge can be used to record the engine blowby. Minimum Gauge Capacity: 1270 mm H 2 0 [50 inches H 2 0].