Cummins — LUBRICATING OIL SYSTEM PRIMING

Priming the Lubricating Oil and Fuel Systems (14-02) Engine Testing N14 Page 14-20 NOTE: If an external pressure pump is not available, prime the lubricating system as follows: Use the dipstick to measure the lubricating oil level. Fill the oil pan to the level mark on the dipstick. Disconnect the turbocharger lubricating oil supply line. Pour 50 to 60 cc [2.0 to 3.0 fl oz] of clean 15W-40 oil in the turbocharger oil supply line fitting. Install the turbocharger oil supply line. Torque Value: 30 [22 ft-lb] Use clean 15W-40 oil to fill the lubricating oil filter. Tighten the filter until the gasket contacts the filter head surface.

Tighten the filter an additional three-fourths to one (3/4 to 1) turn.