Cummins — FUEL SYSTEM PRIMING - PT SYSTEM

Priming the Lubricating Oil and Fuel Systems (14-02) Engine Testing N14 Page 14-22 Install the filter on the filter head and tighten the filter until the gasket contacts the filter head surface. Tighten the filter an additional one-half to three-fourths (1/2 to 3/4) turn. Fuel System Priming - PT System To reduce engine cranking time, prime the fuel pump. NOTE: If the fuel pump is dirty, clean the outside of the pump near the filter screeen cap. Remove the plug from the top of the fuel pump housing. Fill the housing with clean fuel. Install the plug in the fuel pump housing. Torque Value: 27 [20 ft-lb] NOTE:

If the priming plug is difficult to remove or the fuel pump is a VS type, use clean fuel to fill the gear pump. Remove the fuel supply hose at the fuel filter or the flow meter and fill the hose with clean fuel. Install the fuel supply hose to the filter head or flow meter.