Cummins — ENGINE BLOWBY

General Test Procedure - Chassis Dynamometer (14-05) Engine Testing N14 Page 14-36 Operate the engine at maximum horsepower RPM and Advertised Horsepower. Observe the reading on the gauge or manometer. NOTE: Restriction must not exceed 635 mm H 2 0 [25 inches H 2 0]. Exhaust Air Restriction Measure the exhaust air restriction. Install the vacuum gauge, Part No. ST-1273, or a manometer in the exhaust air piping. NOTE: The gauge adapter must be installed near the turbo- charger in a straight section of pipe at the turbine outlet. Operate the engine at maximum horsepower RPM and advertised horsepower. Observe the gauge or manometer. NOTE: Pressure must not exceed 75 mm Hg [3.0 inches Hg].

Engine Blowby Measure the engine crankcase pressure. Use blowby checking tool, Part No. 3375150, and water manometer, Part No. ST-1111-3.