Engine Run-In Procedure - Chassis Dynamometer (14-06) Engine Testing N14 Page 14-38 Engine Run-In Procedure - Chassis Dynamometer (14-06) NOTE: Refer to Chassis Dynamometer Operation, Proce- dure 14-04, for general operating procedures and safety precautions. NOTE: Operate the vehicle in a gear that produces a road speed of 90 to 100 km/h [55 to 60 mph] at maximum horse- power RPM. Monitor and record the following measurements during run-in: Compulink (install on CELECT™engines) Lubricating oil pressure Coolant temperature Fuel pressure Torque Blowby Engine speed (RPM) Fuel flow (use service tool, Part No.
3376375) Refer to the Chassis Dynamometer worksheet on the last page of this procedure. To correctly evaluate the engine performance, this ad- ditional measurement, intake manifold pressure (Turbo- charger boost), must be observed during engine run-in phases. Refer to the Engine Dynamometer worksheet on the last page of this procedure. NOTE: It is recommended to monitor block coolant pressure during run-in to aid in early indication of a cooling system problem. Obtain CPL number from the engine data plate and the fuel pump code from the fuel pump data plate.
Engine performance specifications and fuel system cal- ibration values are listed for specific engine CPL and fuel pump codes in the following publications: 1. Fuel Pump Calibration Values, Bulletin No. 3379352. 2. Injector Parts Flow and Cross Reference, Bulletin No. 3379664. 3. Engine Data Sheets 4. N14 Troubleshooting and Repair Manual, Bulletin No. 3810456