Engine Testing Engine Run-In Procedure - Chassis Dynamometer (14-06) N14 Page 14-39 If a sudden increase in blowby occurs, or if blowby ex- ceeds the maximum allowable limit during any run-in, return to the previous step and continue the run-in. If blowby does not reach an acceptable level during the next step, discontinue the run-in and determine the cause. Do not proceed to the next step until a steady, acceptable blowby reading is obtained. NOTE: Blowby must be measured by using Service Tool, Part No. 3375150 or 3822566 with manometer, Part No. ST-1111-3, or equivalent. Service Tool, Part No. 3375150, as shown, utilizes a chamfered 7.67 mm [0.302 in] orifice.
Move the throttle to obtain 1200 RPM engine speed, and apply a test load sufficient to develop 25 percent rated fuel pressure or 25 percent fuel rate on CELECT™en- gines. Operate the engine at this speed and load level until the coolant temperature reaches 71°C [160°F]. Operate the engine at maximum horsepower RPM and 75 percent of rated fuel pressure or 75 percent fuel rate on CELECT™engines for 3 minutes. Check the gauges, and record the readings. NOTE: Do not proceed to the next step until a steady, acceptable blowby reading is obtained. Operate the engine at maximum horsepower RPM and Advertised Horsepower with a wide open throttle, for 5 minutes.
Check the gauges, and record the readings.