Engine Run-In Procedure - Chassis Dynamometer (14-06) Engine Testing N14 Page 14-40 Operate the engine at nominal torque peak RPM, full load, wide open throttle, for 5 minutes. Check the gauges, and record the readings. NOTE: Refer to the engine ‘‘Data Sheet’’ for the torque peak RPM of the engine model being tested. Operate the engine at maximum horsepower RPM and Advertised Horsepower with a wide open throttle for 5 minutes. Check the gauges, and record the readings. Compare the readings to those published on the appro- priate engine Sheet’’. Caution: Do not shut off the engine immediately after the run-in is completed.
Allow the engine to cool by operating it at 700 to 900 RPM for a minimum of 3 to 5 minutes to avoid internal component damages. This al- lows the turbocharger and other components to cool. Shut off the engine. Make sure all instrumentation is removed before remov- ing the vehicle from the chassis dynamometer.