Cummins — INSPECTION

Mounting Adaptations Flywheel - Cleaning and Inspection for Reuse (16-01) N14 Page 16-5 Flywheel - Cleaning and Inspection for Reuse (16-01) Cleaning Use a wire brush to clean the crankshaft pilot bore. Steam clean or use a solvent, and dry with compressed air. Inspection Visually inspect for nicks or burrs. Use a fine crocus cloth to remove small nicks and burrs. Warning: Do not use a cracked or resurfaced flywheel. These can break, causing serious personal injury or prop- erty damage. Use crack detection kit, Part No. 3375432, to check for cracks in the flywheel. Follow the instructions provided with the kit. Inspect the flywheel ring gear teeth for cracks and chips. NOTE:

If the ring gear teeth are cracked or broken, the ring gear must be replaced.