Flywheel Ring Gear - Replacement (16-02) Mounting Adaptations N14 Page 16-6 Flywheel Ring Gear - Replacement (16-02) Caution: Do not use a cutting torch to heat the ring gear. The flywheel can be damaged. Heat the outside diameter of the ring gear with a heating torch. Use a blunt chisel and a hammer to remove the gear from the flywheel. Caution: Do not overheat the ring gear. The metal hard- ness will be changed. Heat the new ring gear in an oven heated to 316°C [600°F] for a minimum of 1 hour. Caution: Wear protective gloves when handling parts that have been heated to prevent personal injury. Remove the gear from the oven, and install it on the flywheel before it cools. NOTE:
If an oven is not available, use a heating torch to heat the inside diameter of the new ring gear to 316°C [600°F]. Use a Tempilstik W crayon or its equivalent to check the gear temperature before installing it on the flywheel. A more even temperature can be obtained by placing the ring gear on a metal plate, then heating the bottom side of the plate with a heating torch. Do not exceed the specified temperature. Flywheel Housing - Cleaning and Inspection for Reuse (16-03) Cleaning Steam clean or use solvent to clean the housing. Dry with compressed air.