Mounting Adaptations Flywheel Housing - Redowel to Cylinder Block (16-04) N14 Page 16-7 Inspection Visually inspect all surfaces for nicks, burrs, or cracks. Use a fine crocus cloth to remove small nicks and burrs. Inspect all threaded capscrew holes for damage. Repair or replace the housing if the capscrew holes are damaged. Flywheel Housing - Redowel to Cylinder Block (16-04) The following tools are needed to perform this procedure: Drill ream fixture, Part No. ST-1232, which contains: (1) Plate, Part No. ST-1232-1 (2) Locator pin, Part No. 3375052 (3) Spacer washer, Part No. ST-1232-2 (4) Drill/ream Bushing set Actual sizes depend on the dowel size Part No.
3376495 (5) Drill adapter Locally obtained; use to adapt open- shank reamers to drill-chuck (6) Reamer Locally obtained (7) Drill bit Locally obtained Remove the flywheel housing. If necessary, refer to En- gine Disassembly, Group 00-01. Use dowel pin extractor, Part No. ST-1134, or its equiv- alent to remove the two dowel pins from the cylinder block.