Cummins — REDOWEL TO CYLINDER BLOCK

Flywheel Housing - Redowel to Cylinder Block (16-04) Mounting Adaptations N14 Page 16-8 Measure and record the diameter of one of the dowel pins which was removed to determine the next oversize dowel to be installed after the housing is aligned. Install the flywheel housing without the dowel pins. Tighten the capscrews. Torque Value: 7 [5 ft-lb] NOTE: Do not tighten the capscrews to the final torque value until the flywheel housing is aligned. Use chalk to mark the housing at the 12:00 o’clock, 3:00 o’clock, 6:00 o’clock, and 9:00 o’clock positions. Attach the dial indicator to the crankshaft as shown.

Use the accessory drive to rotate the crankshaft until the dial indicator is at the 3:00 o’clock position. Adjust the dial indicator until the needle points to 0. Rotate the crankshaft until the indicator is at the 9:00 o’clock position. Check the total indicator reading.