Mounting Adaptations Flywheel Housing - Redowel to Cylinder Block (16-04) N14 Page 16-9 If the total indicator reading exceeds the limits listed in Section 00-02 ‘‘Flywheel Housing Installation,’’ use a mallet to horizontally move the housing one-half the dis- tance of the total indicator reading. Rotate the crankshaft until the indicator is at the 12:00 o’clock position. Adjust the dial until the needle points to Rotate the crankshaft until the indicator is at the 6:00 o’clock position. Check the total indicator reading.
If the total indicator reading exceeds the limits listed in Section 00-02 ‘‘Flywheel Housing Installation,’’ use a mallet to vertically move the housing one-half the dis- tance of the total indicator reading. Rotate the crankshaft until the indicator is at the 12:00 o’clock position. Adjust the dial until the needle points to 0. Rotate the crankshaft, and record the indicator reading at the 3:00 o’clock, 6:00 o’clock, and 9:00 o’clock positions. If the total indicator reading exceeds the limits listed in Section 00-02 ‘‘Flywheel Housing Installation,’’ repeat the previous steps. After the housing bore is aligned, check to make sure the surface of the housing is in alignment.
Refer to Section 00-02 ‘‘Flywheel Housing Installation - Face Alignment.’’