Cummins — REDOWEL TO CYLINDER BLOCK

Mounting Adaptations Flywheel Housing - Redowel to Cylinder Block (16-04) N14 Page 16-11 The dowel must be long enough to protrude from the block one-half of the flywheel housing wall thickness but must not protrude past the housing wall. NOTE: There are three oversize dowel pins available: Oversize Dowel Pin O.D. Overall Dimension Amount Oversize mm in mm in 13.08 [0.515] 0.38 [0.015] 13.46 [0.530] 0.76 [0.030] 13.84 [0.545] 1.14 [0.045] Install the appropriate drill bushings. The Table shows the bushings available in Part No. 3376495. Drill/Ream Bushing Set 25.4 mm [1 inch] O.D. The drill bushing used must be the same size as the reamer (or the drill) which is used.

Bushing Size [inch] 3376495 Special 12.304 [0.4844] Standard 12.700 [0.5000] 0.38 [0.015] 13.096 [0.5156] 0.76 [0.030] 13.494 [0.5312] 1.14 [0.045] 13.879 [0.5464] Bushing Size mm Oversize mm Oversize [inch] If the new dowel pins are more than 0.38 mm [0.015-inch] larger than the old dowels, drill the hole to a size that is slightly smaller than the reamer. Then the reamer will not have to remove an excessive amount of material. Caution: Do not allow metal chips to enter the engine. Damage to the engine will result. Ream the hole until the reamer touches the bottom of the hole in the block.