Flywheel Housing - Redowel to Cylinder Block (16-04) Mounting Adaptations N14 Page 16-12 After reaming one hole, turn the plate and align it with the second dowel hole. Repeat the procedure in the second hole. Remove the plate from the crankshaft. Caution: To avoid possible engine damage, make sure the dowel hole does not contain any metal chips. Use a square nose drift. Drive each dowel in until it touches the bottom of the hole in the block. After the dowels are installed, measure the bore and the surface alignment again. Use a square nose drift. Stake the dowel holes to prevent the dowels from coming out.