Cummins — SPECIFICATIONS

Engine Assembly - Specifications Specifications Page 18-10 NT 855 Part or Assembly Ref. Point mm in Piston Ring Gap Piston Top 0.43 MIN 0.017 0.68 MAX 0.027 Second 0.51 MIN 0.020 0.76 MAX 0.030 Third 0.48 MIN 0.019 0.74 MAX 0.029 Oil 0.25 MIN 0.010 0.64 MAX 0.025 Note: Add 0.08 mm [0.003-inch] to the maximum limit for each 0.03 mm [0.001-inch] wear in the cylinder liner wall. Oil Control Ring End Gap The two-piece oil ring must be installed with the expander gap 180 degrees from the oil ring gap. Piston Ring End Gap The ring gaps must not be aligned with the piston pin bore. Rotate the rings to position the gaps as shown. Connecting Rod Side Clearance 0.114 MIN 0.0045 0.33 MAX 0.13 Note:

The rod must move freely from side-to-side. Engine Timing Note: The timing marks on the camshaft gear must align with the timing marks on the crankshaft gear to make sure the engine timing is set correctly. Backlash Between the Camshaft and 0.05 MIN 0.002 the Crankshaft Gear 0.50 MAX 0.020 Injection Timing To verify the correct injection timing for a particular engine refer to the engine dataplate. Refer to Group 00, Engine Assembly, Injection Timing, Page 0-89, for complete instructions.