Specifications Engine Assembly - Specifications NT 855 Page 18-11 Part or Assembly Ref. Point mm in Accessory Drive Assembly Timing Position the accessory drive shaft dowel pin at the 12:00 o’clock position. Align the timing mark on the accessory drive gear with the timing mark on the camshaft gear. Backlash Between the Accessory 0.05 MIN 0.002 Drive and the Camshaft Gear 0.50 MAX 0.020 Note: If the backlash is not within specifications, the gear must be replaced. Backlash Between the Lubricating 0.05 MIN 0.002 Oil Pump Drive Gear and the 0.50 MAX 0.020 Camshaft Gear Note: If the backlash is not within specifications, the lubricating oil pump drive gear must be replaced.
Vibration Damper Eccentricity T.I.R. 0.10 MAX 0.004 Vibration Damper Face Alignment T.I.R. 0.18 MAX 0.007 Flywheel Bore Runout T.I.R. 0.127 MAX 0.0050 Radius (A) mm in Flywheel Face Runout T.I.R. 203 8 0.203 MAX 0.008 254 10 0.254 MAX 0.010 305 12 0.305 MAX 0.012 356 14 0.356 MAX 0.014 406 16 0.406 MAX 0.016