Cummins — CELECT ENGINES

Engine Disassembly (00-01) Valve Crossheads - Removal N14 Page 0-35 Valve Crossheads - Removal Remove the crossheads. Be sure to mark them appro- priately so they can be installed in the same location and orientation during the installation procedure. NOTE: Excessive crosshead wear can result if the cross- heads are not installed in their original locations. The larger hole on the underside of the crosshead must be oriented toward the exhaust side of the engine. Push Tubes - Removal Remove the push tubes. NOTE: To prevent increased wear, mark each push tube as it is removed so it can be installed back in its original location.

Injectors - Removal CELECT™Engines Disconnect the injector solenoid leads from the pass through connector in the rocker housing. Remove the injector hold down clamp capscrew. Remove the injector and the hold down clamp. Use injector puller, Part No. 3823579, to remove CELECT™injectors. Insert the pin of the tool into the hole provided in the body of the injector. The hole faces the exhaust side of the engine. Caution: Do not catch the injector puller into the top stop spring cage. Damage to the injector will occur.