Rocker Lever Housing - Removal Engine Disassembly (00-01) N14 Page 0-36 STC Engines Remove the injector hold down clamp capscrew and the clamp. Use injector puller, Part No. 3822697, to remove the STC injectors. Insert the threaded end of the puller into the tapped hole in the STC oil feed lock nut. Remove the internal oil tube and the rubber grommet which is located in the cylinder head. Rocker Lever Housing - Removal Remove the water manifold tube clamps. Use service tool, Part No. 3823819, to push or pry the adjacent water tubes into the rocker housing cavity. For example, the tube between housing No. 1 and No. 2 must be pushed into housing No. 2. The tube between housing No. 2 and No.
3 must be pushed into housing No. 3. Remove the rocker housing mounting capscrews. NOTE: To prevent increased wear, mark each rocker lever housing as it is removed so it can be installed back in its original location. If the rocker housing assemblies are to be installed after rebuild with their original parts, mark each rocker lever housing as it is removed so it can be installed back in its original location thus taking advantage of worn-in mating parts.