Cylinder Liners - Removal Engine Disassembly (00-01) N14 Page 0-42 Remove the upper rod bearing. Mark the cylinder number and the letter in the flat surface of the bearing tang. Caution: Do not over expand the piston rings. Maximum gap at assembly is 1.63 inches. Use the piston ring expander, Part No. 3823871, to re- move the piston rings. Put a tag on the rings, and record the cylinder number of the piston on the tag for future reference (if required). Use internal snap ring pliers to remove the snap rings from both sides of the piston. Caution: Do not use a hammer to remove the piston pins. The piston can distort and cause the piston to seize in the liner.
Use a blunt tool to push the piston pin from the piston and rod assembly. Cylinder Liners - Removal Caution: The liner puller must be installed and used as described to avoid damage to the cylinder block. When using cylinder liner puller, Part No. 3376015, insert the liner puller in the top of the cylinder block. NOTE: The liner puller must be centered on the top of the cylinder block. The feet on the extension arms must be extended below the bottom of the liner.