Engine Disassembly (00-01) Piston and Connecting Rod Assemblies - Removal N14 Page 0-41 Install two connecting rod guide pins, Part No. 3375601. Use a piston pusher to push the rod away from the crankshaft. NOTE: Push the rod away from the crankshaft, over the crankshaft rod journal, and push the rod until the piston rings are outside of the top of the cylinder liner. Remove the piston and rod assembly. NOTE: The piston and connecting rod assemblies must be installed in the same cylinder number from which they were removed to make sure correct fit of worn mating surfaces if parts are to be used again. Use a tag to mark the cylinder number from which each piston and rod assembly was removed.
NOTE: The pistons must have the cylinder numbers stamped on the piston top toward the camshaft side of the engine. Put the rod and piston assemblies in a stand to protect them from damage. Caution: The rod cap alpha-numeric characters must match the alpha-numeric characters on the connecting rod and must be installed with the characters aligned to prevent damage to the connecting rods and the crankshaft.