Piston and Connecting Rod Assemblies - Removal Engine Disassembly (00-01) N14 Page 0-40 Use one hand to slowly rotate and pull the camshaft from the cylinder block and the other hand to balance the camshaft as it is removed. Remove the camshaft thrust washer from the camshaft. Piston and Connecting Rod Assem- blies - Removal Caution: Piston cooling nozzles must be removed prior to the removal of the piston and connecting rod assem- blies. Plug the overhead oil rifle, push tube cavities, and coolant passages in the block; and use a rotary wire brush to remove the carbon ring from the top of the cylinder liner. Use a scraper that has an aluminum blade if a rotary wire brush is not available.
Use lint-free paper to remove all the broken wire bristles and loose carbon from the cylinders. Rotate the crankshaft to position two of the connecting rods at bottom dead center (BDC). Loosen the connecting rod capscrews. NOTE: Do not remove the capscrews. Hit the connecting rod capscrews with a rubber hammer to loosen the rod caps from the dowels. Remove the connecting rod capscrews and the rod caps. Remove the bearing shell from the rod cap, and mark the cylinder number and the letter in the flat surface of the bearing tang.