Cummins — CAMSHAFT - REMOVAL

Engine Disassembly (00-01) Lubricating Oil Pan - Removal N14 Page 0-39 Lubricating Oil Pan - Removal Remove the oil pan mounting capscrews and the oil pan. Gear Cover - Removal Remove one capscrew on each side of the gear cover, and install a 7/16 - 20 X 4-inch guide stud in each location to support the cover during removal. Remove the remaining gear cover capscrews, and re- move the gear cover. Crankshaft Seal, Front - Removal Remove the front crankshaft seal. Accessory Drive Seal - Removal Remove the accessory drive seal. Refer to the N14 Trou- bleshooting and Repair Manual, Bulletin No. 3810456, Section 7. Camshaft - Removal Install four camshaft pilots, Part No.

3375268, over the outer base circle of the valve lobes between the camshaft journals. Use a rubber band to hold the installation pilots in place. The rubber band must straddle the valve lobe.