Cummins — CAMSHAFT BEARING SUPPORT - REMOVAL

Cam Follower Assemblies - Removal Engine Disassembly (00-01) N14 Page 0-38 Cam Follower Assemblies - Removal Remove the cam follower housing assemblies as follows: 1. Remove the six capscrews and studs from each cam follower housing. NOTE: Record the position of the studs prior to removal. NOTE: To prevent increased wear, mark the cam follower housing assemblies as they are removed so they can be installed back in their original location on the block. 2. Remove the cam follower housings and gaskets. Camshaft Bearing Support - Removal Remove the three capscrews from the support. Use a rubber or plastic mallet to rotate the bearing sup- port approximately 60 degrees.

Use a suitable pry bar to remove the bearing support from the gear cover. NOTE: Be careful not to damage the bearing support surfaces. Remove the o-ring and the shims from the bearing sup- port. Do not dispose of the shims.