Cummins — CRANKSHAFT - REMOVAL

Crankshaft - Removal Engine Disassembly (00-01) N14 Page 0-44 Use a liquid metal marker to mark the cylinder number on each liner. If the sealing rings were removed, do the following: 1. Use a tag to mark the cylinder number. 2. Measure in several places and record the thickness of the sealing rings used in each cylinder. The thickness of the sealing ring is one factor in determining liner protrusion. This information must be known when the liners are installed in the engine. Crankshaft - Removal Caution: The main bearing caps must be marked for position and cylinder block identification.

The position number (1) of the cap is stamped on the camshaft side and the block identification number (2) is stamped on the exhaust side of the cap. The cylinder block identification number is stamped on the front and the rear of the oil pan flange on the camshaft side of the engine. Check and mark all caps that are not marked before removing them from the cylinder block. NOTE: The No. 7 main bearing cap has thrust bearings and dowel pins. Remove the main bearing capscrews and the washers.