Cummins — CRANKSHAFT - REMOVAL

Engine Disassembly (00-01) Crankshaft - Removal N14 Page 0-45 Use main bearing cap puller, Part No. ST-1178, to re- move the caps. The service tool must be centered on the main bearing cap. NOTE: Use a pencil or scribe to mark the bearing shells with the journal number from which they were removed if they are to be used again or if failure analysis is required. Mark the bearing on the back side or in the locating tang. Remove the lower main bearing shell from the crankshaft journal. Remove the dowel ring. Remove the thrust bearings from the No. 7 cap. Mark these bearings as the front and the rear thrust bearings. Caution: Do not damage the crankshaft when removing the thrust bearings.

Use a blunt tool to remove the upper thrust bearings. Mark these bearings in the notched area as the front and the rear thrust bearings. NOTE: If necessary, slide the crankshaft to the front or to the rear to allow the thrust bearings to be removed.