Cummins — CYLINDER BLOCK - INSTALLATION ON THE REBUILD STAND

Cylinder Block - Removal from the Rebuild Stand Engine Assembly (00-02) N14 Page 0-46 Warning: Because this part weighs more than 23 kg [50 lbs], two people or a hoist will be required to lift the crankshaft to avoid personal injury. Use a hoist and a lifting sling to remove the crankshaft. Push the upper main bearing on the end that does not have the dowel ring groove. NOTE: Mark the bearing shells with the journal number from which they were removed if they are to be used again or if failure analysis is required. Cylinder Block - Removal from the Rebuild Stand Use a nylon lifting sling, Part No. 3375957 (with a leather sleeve), to lift the cylinder block.

Remove the capscrews and the cylinder block from the rebuild stand. Refer to Cylinder Block, Group 01, for cleaning and in- spection purposes. Engine Assembly (00-02) Cylinder Block - Installation on the Rebuild Stand NOTE: Use the engine rebuild stand, Part No. 3375194, and the adapter plate, Part No. 3375013. Use six 5/8 - 11 X 1 3/4-inch grade 5 capscrews to install the adapter plate to the rebuild stand. Torque Value: 102 [75 ft-lb]