Cummins — CYLINDER BLOCK - INSTALLATION ON THE REBUILD STAND

Engine Assembly (00-02) Cylinder Block - Installation on the Rebuild Stand N14 Page 0-47 Install the mounting plate adapter on the rear water header if removed during the cleaning or inspection procedure. Use five 1/4-20 X 1 1/4-inch capscrews to mount the adapter. Torque Value: 10 [7 ft-lb] Install three 1/2-13 X 3 3/8-inch capscrews through the adapter plate as shown. Install the three adapter plate spacers over the capscrews. Use a nylon lifting sling, Part No. 3375957, (with a leather sleeve), to lift the cylinder block. Put the oil cooler side of the cylinder block to the adapter plate of the rebuild stand.

Align the mounting hole in the adapter plate (1) with the capscrew hole (2) in the mounting plate adapter. Use one 5/8-11 X 1 3/4-inch grade 5 capscrew to mount the adapter plate to the mounting plate adapter. Use your fingers to tighten the capscrew.