Engine Assembly (00-02) Crankshaft - Installation N14 Page 0-51 Use a lint free cloth to clean the thrust bearings, the main bearing shells, and the main bearing caps. NOTE: If used thrust bearings are to be installed, each must be installed in its original location in the engine. The bearing journal numbers must have been marked on the bearing during disassembly. Use clean Lubriplate T 105 or its equivalent to lubricate the upper thrust bearings. Caution: The grooves must be toward the crankshaft. Install the upper thrust bearings in the No. 7 main bearing saddle. NOTE:
Push the crankshaft toward the front of the engine to install the front bearing and to the rear of the engine to install the rear bearing. The end of the thrust bearings must be even with the main bearing cap mounting surface. Caution: Do not intermix the main bearing dowel ring and the main bearing capscrew washers. The hardened main bearing capscrew washer (1) is approximately 0.76 mm [0.030-inch] thicker than the soft main bearing dowel ring (2). Intermixing the capscrew washers and dowel rings will result in main bearing failure.