Cummins — CRANKSHAFT - INSTALLATION

Crankshaft - Installation Engine Assembly (00-02) N14 Page 0-50 Align the ring dowel groove in the bearings with the count- erbore in the cylinder block, and install the bearings. Both ends of the bearing will be approximately 1.50 mm [0.060-inch] below the main bearing cap mounting sur- face when installed correctly. Caution: Prevent dirt from mixing with the lubricant. Dirty lubricant will cause low mileage failures. Use clean Lubriplate T 105 or its equivalent to lubricate the upper bearing shells. Use a lint free cloth to clean the crankshaft bearing journals. Warning:

Because this part weighs more than 23 kg [50 lbs], two people or a hoist will be required to lift the part to avoid personal injury. Caution: Use a lifting strap that will not damage the crankshaft. Do not drop the crankshaft on the bearings. The end of the crankshaft with the smallest diameter must point toward the front of the block. Install the crankshaft.