Engine Assembly (00-02) Crankshaft - Installation N14 Page 0-49 Caution: The upper main bearing shells have a groove and an oil hole to provide crankshaft lubrication. The lower main bearing shells do not. Both bearings are marked on the back to indicate the location and either standard (std.) or oversize (OS). The amount of OS is stamped on the back in U.S. customary inches. The groove for the No. 7 shell is not in the center of the shell. The wider part of the No. 7 shell must be installed toward the flywheel end of the cylinder block. NOTE: If used bearing shells are to be installed, each must be installed in its original location in the engine.
The bearing journal numbers must have been marked on the bearing during disassembly. Caution: Do not lubricate the back of the bearing. Use a lint free cloth to clean the bearing and the mounting surface.