Cummins — CRANKSHAFT - INSTALLATION

Engine Assembly (00-02) Crankshaft - Installation N14 Page 0-55 Tighten the main bearing capscrews to the following torque values: 1. Tighten to 122 [90 ft-lb]. 2. Tighten to 230 [170 ft-lb]. 3. Tighten to 346 [255 ft-lb]. 4. Loosen completely. 5. Repeat steps 1 through 3. After tightening all the main bearing capscrews, use your hands to turn the crankshaft. If it does not turn freely, loosen the main bearing capscrews one cap at a time. This will help locate the bearing that is too tight. Remove the main bearing cap and the bearing. Check for an incorrect or mislocated bearing or main bearing cap, an incorrect oversize bearing, or debris between the main bearing and the cap.

Tighten the main bearing capscrews in the sequence shown to the torque values listed previously in this procedure.