Cummins — CRANKSHAFT - INSTALLATION

Crankshaft - Installation Engine Assembly (00-02) N14 Page 0-56 Measure the end clearance of the crankshaft. Install a dial indicator to the rear face of the cylinder block. Put the tip of the gauge against the end of the crankshaft. Push the crankshaft toward the rear of the cylinder block. Set the dial indicator to ‘‘0.’’ Push the crankshaft toward the front of the cylinder block. If the end clearance is less than 0.10 mm [0.004-inch], do the following: Loosen the main bearing capscrews one turn. Push the crankshaft toward the front and then toward the rear of the cylinder block.

Tighten the main bearing capscrews in the sequence shown to the torque values listed previously in this procedure.