Engine Assembly (00-02) Cylinder Liners - Installation N14 Page 0-57 Measure the crankshaft end clearance. The end clear- ance specification for a new or reground crankshaft with new thrust bearings is 0.10 mm [0.004-inch] to 0.45 mm [0.018-inch]. NOTE: Crankshafts that have been reground on the thrust bearing surfaces are marked for oversize thrust bearings on the rear crankshaft counterweight. If the crankshaft coun- terweight is marked, check the thrust ring part number to make sure the correct thrust ring size is used. Example: F-.010 - Front 0.25 mm [0.010-inch] Example:
R-.020 - Rear 0.51 mm [0.020-inch] If the crankshaft end clearance is more than 0.58 mm [0.023-inch], use oversize thrust bearings to adjust the end clearance to the correct specification. Cylinder Liners - Installation NOTE: Make sure the cylinder block and all parts are clean before assembly. If used liners are being installed again, any sealing rings removed must be installed with the same liner in the same cylinder. Use vegetable oil to lubricate the new liner o-rings and the crevice seals. NOTE: Use vegetable oil to lubricate the o-rings. Do not use lubricating oil on the o-rings. The o-rings will increase in size after they have been lubricated with oil.